Technical Data Sheet
| Document | RY-TDS-801 |
|---|---|
| Revision | Rev. 1.0 |
| Issue date | July 2026 |
| Status | Issued |
Rayson GripSafe · Anti-slip systems
Rayson GripSafe AP12 is a one-pack, self-crosslinking acrylic primer filler loaded with 0.5–1.5 mm silicate quartz aggregate that builds an anti-slip texture directly onto concrete and asphalt.
GripSafe AP12 puts the anti-slip aggregate in the can. Instead of broadcasting loose grit into a wet primer, the 0.5–1.5 mm silicate quartz is factory-blended into a self-crosslinking acrylic binder — so every pass lays down a consistent, repeatable texture. It doubles as primer and filler, keying subsequent finish coats.
Primer.
Figure 1 — Typical system build-up (top to bottom). Layer thicknesses are system-dependent; confirm the specification for your project.
| Surface preparation | Surface must be dry and clean — free of poorly adhered old coatings, loose particles, dust, grease, oil, wax and biological growth. Fill and level defective or cracked areas with a suitable filler, allow to dry, sand level and remove dust before coating. |
|---|---|
| Mixing / dilution | Single component, ready to use; condition material to 15–25 °C before use |
| Application method | Trowel or squeegee, Brush for stripe-coating edges |
| Coverage | Theoretical 5–8 m² per litre, subject to substrate porosity and application conditions |
| Application conditions | Material temperature 15–25 °C; ambient and surface temperature above 10 °C and at least 5 °C above the dew point. |
| Drying & curing | Touch dry 30–60 minutes at 25 °C; recoat after 2–4 hours; full cure 1 day |
| Recoat interval | Approximately 2–4 hours. |
| Film / thickness | Textured filler coat; profile set by application. |
| Pack sizes | 22 L plastic pail |
| Storage | Keep away from direct sunlight in a sheltered area. |
| Shelf life | Approximately 12 months unopened. |
Figure 2 — Application workflow. Each stage is a hold point: confirm the previous stage is complete and within specification before proceeding.
Anti-slip walkway or ramp
Low-odour water-based product. Wear gloves and eye protection; ensure reasonable ventilation. Avoid skin and eye contact. Keep out of reach of children. Consult the Safety Data Sheet (in preparation) before use.